Gaspedaal bussen - Delrin

SKU: TCP0028
Item 48 of 48
€ 32,50 (including VAT)

BMW DELRIN ACCELERATOR BUSHINGS (35411119016)

One of the most neglected bushings on your classic BMW is this little accelerator bushing that connects the throttle linkage under the dash. This can cause a sloppy accelerator feel and at times, squeak when the gas pedal is pushed. The original bushings have been pushed thousands of times. Sure, you can replace it with another OEM unit (part number 35411119016). But even the new units are very soft. Do it once, do it right. by using our Delrin accelerator bushings as a replacement to the stock bushings, this is a permanent fix! Comes with an installation tool, for a simplified install. Lubricate with lithium grease on installation to ensure quiet service for years to come.

COMPATIBILITY

  • Fits BMWs that have the bushing 35411119016. Please check on realoem.com before ordering to make sure that this will work on your car.
  • E30: 84-92 ALL
  • E34: 89-95 (530i &535i) (will not fit E34 M5)
  • E24: 77-86 (628, 633, 635, M6)
  • E28: ALL
  • Note: Must be lubricated on installation. COMES WITH TOOL FOR EASY INSTALLATION.

WHAT'S INCLUDED?

  • Accelerator bushing
  • Installation tool

INSTRUCTIONS

**THIS PROCESS WILL DIFFER DEPENDING ON YOUR CHASSIS**

Step 1: Remove the accelerator pedal by removing the c-clip or pushing in the pin on the back right side of the pedal followed by the bottom clip behind the pedal.

Step 2: Remove the throttle cable from the bracket

Step 3: Locate and remove the accelerator pedal pivot bracket clip holding it in place, this will allow you to remove the assembly

Step 4: Remove the old worn out bushings

Step 5: Grab the bolt and one washer from the provided press tool. Put the washer on the bolt followed by one of the bushings with the flat side towards the washer.

Step 6: Place the cup from the press tool over the lip, if your vehicle does not have the lip it will be on the outside. The inside referring to the middle of the accelerator bracket.

Step 7: Take the bolt with the washer and bushing and insert it from the opposite side of the cup and place the other washer and nut and hand tighten it.

Step 8: Hold one end and tighten the other side and the bushing will start to press in.

Shopping cart

No items in shopping cart.

E30 Summer Meet 2024

Op 17 en 18 augustus 2024 vindt de E30 Summer Meet 2024 Powered by Tim's Classic Parts plaats! Over de 200 E30's verzamelen zich dan in Appeltern voor een heel weekend E30 fun! Hier is Tim's Classic Parts ook bij aanwezig met een stand.
Koop je tickets in de Ticketshop of bekijk meer info op de website.

BMW E30 Club Nederland

Ik ben mede-oprichter en voorzitter van de Nederlandse BMW E30 Club. Dit is een zeer actieve E30 club met over de 300 clubleden. We bezoeken en organiseren diverse uitjes, evenementen en toertochten elk jaar.

Als Clublid ontvang je ook leuke kortingen, waaronder bij mij!

Lijkt je dit ook wat, neem dan zeker eens een kijkje op de Clubsite.

© 2020 - 2024 tims-classic-parts | sitemap | rss | ecommerce software - powered by MyOnlineStore

Due to participation in Techno Classica Essen 2024, no orders will be sent between 29th March 12:00 CET and 8th April .